[Ltib] R: Question about file execution

[Roberto Giovoni]

Yes is true.

I need to be in the same directory as the file I'am trying to execute using
./

Thanks for your help

                Giovoni Roberto

-----Messaggio originale-----
Da: Stuart Hughes [mailto:address@hidden
Inviato: domenica 17 aprile 2011 19.41
A: Roberto Giovoni
Cc: address@hidden; 'Ronco'
Oggetto: Re: [Ltib] Question about file execution


Hi Roberto,

Maybe I misunderstand you?, but you need to be in the same directory as
the file you're trying to execute using ./ (not the one above).
So you would need to do:

cd /home/teledata/Pulsar
./Pegasus

Regards, Stuart

On 15/04/11 10:21, Roberto Giovoni wrote:
> We have created a file system image for LPC3250 for Phytec board
> with linux kernel image ver 2.6.34.
>
> We have the following problem:
>
> 1) we have copied in /home/teledata/Pulsar directory our Pegasus
executable
> file
> 2) we start to run this file (always from directory above) with the line
> command ./Pegasus
> 3) we obtain the message ""-/bin/sh: ./Pegasus: not found"
> 4) using the file system image provided with the Phytec board, with
>    our created linux image (ver 2.6.34), the line command described
>    at point 2 is working well (the file runs).
>
> There is someone that can help us?
>
> Pegasus file attached.
>
>                                   Thanks in advance for your help
>
>
> Roberto Giovoni
>
>    s.r.l.
>
> Via Giulietti, 8 - 20132 Milano
> address@hidden
> www.teledata-i.com < <http://www.teledata-i.com>>
> Tel. +39 0227201352 ( int.25) - Fax. +39 022593704
>
>
>
>
> _______________________________________________
> LTIB home page: http://ltib.org
>
> Ltib mailing list
> address@hidden
> http://lists.nongnu.org/mailman/listinfo/ltib