Re: [Paparazzi-devel] Lisa M wiring layout

[Eduardo lavratti]

Bruzzlee, i am using lisa/m too.
Please, report your tests to the group.

I have strange behavior with my copter.
Some of this caused by vibration and other that i not know the cause.

regards.

> From: address@hidden
> Date: Sun, 1 Jan 2012 01:46:19 +1030
> To: address@hidden
> Subject: Re: [Paparazzi-devel] Lisa M wiring layout
>
> Hi Bruzzlee
>
> It looks good to me and yes the ADC1 bridge is needed only for the initial bind to the Spektrum receiver (or receivers, you can use two at once)
>
> Eric
>
> On 30/12/2011, at 7:51 AM, Bruzzlee wrote:
>
> > Hi all
> > After a long break I've continued the work on my quadrotor Lisa M project. Now I've done my wiring layout but I'm not sure if everything is correct.
> > Especially the power source for the board: I2C1 CAN (V_BATT/GND) or SERVO1 (SV/GND)?
> > The ADC1 bridge - I need it only for the first binding to the spectrum remote - right?
> >
> > I want to publish this layout on wiki - please report mistakes!
> >
> > thx
> > Bruzzlee
> > <LisaMWiring.png>_______________________________________________
> > Paparazzi-devel mailing list
> > address@hidden
> > https://lists.nongnu.org/mailman/listinfo/paparazzi-devel
>
>
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
> https://lists.nongnu.org/mailman/listinfo/paparazzi-devel