[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Eagle Tree Airspeed Sensor Problem

From: Eduardo lavratti
Subject: Re: [Paparazzi-devel] Eagle Tree Airspeed Sensor Problem
Date: Fri, 14 Jun 2013 08:48:32 -0300

I have this sensor and yapa2 and it work fine.

> From: address@hidden
> Date: Fri, 14 Jun 2013 00:12:34 -0500
> To: address@hidden
> Subject: [Paparazzi-devel] Eagle Tree Airspeed Sensor Problem
> Hello all,
> I am trying to put to work the Eagle Tree airspeed sensor on a YAPA2 connected to the I2C port as described on the wiki. Every time I turn on the autopilot and then power the eagle tree sensor my autopilot freezes (the LEDs on the autopilot board stop blinking), I can see that I only get error packages on the telemetry link and my Ground Station stops receiving information.
> I have connected the sensor as described on the wiki (GND to white, +5V to Red, SDA to Yellow and SCL to brown). To power the sensor I connected the Red cable to one of the +5V ports used to power the servos and I also tried connecting it directly to the 14V battery that I am using to power the YAPA2 with the same results.
> Anyone has any thoughts?
> Best Regards,
> Jorge
> _______________________________________________
> Paparazzi-devel mailing list
> address@hidden
i have the same

reply via email to

[Prev in Thread] Current Thread [Next in Thread]