|Subject:||Re: [Paparazzi-devel] Eagle Tree Airspeed Sensor Problem|
|Date:||Fri, 14 Jun 2013 14:06:53 +0200|
I have this sensor and yapa2 and it work fine.> From: address@hidden
> Date: Fri, 14 Jun 2013 00:12:34 -0500
> To: address@hidden
> Subject: [Paparazzi-devel] Eagle Tree Airspeed Sensor Problem
> Hello all,
> I am trying to put to work the Eagle Tree airspeed sensor on a YAPA2 connected to the I2C port as described on the wiki. Every time I turn on the autopilot and then power the eagle tree sensor my autopilot freezes (the LEDs on the autopilot board stop blinking), I can see that I only get error packages on the telemetry link and my Ground Station stops receiving information.
> I have connected the sensor as described on the wiki (GND to white, +5V to Red, SDA to Yellow and SCL to brown). To power the sensor I connected the Red cable to one of the +5V ports used to power the servos and I also tried connecting it directly to the 14V battery that I am using to power the YAPA2 with the same results.
> Anyone has any thoughts?
> Best Regards,
> Paparazzi-devel mailing list
i have the same
Paparazzi-devel mailing list
|[Prev in Thread]||Current Thread||[Next in Thread]|