Re: [Discuss-gnuradio] RFX400 for FRS -- Newbie

[George Nychis]

Eric Blossom wrote:
> On Wed, Sep 05, 2007 at 11:37:46AM -0700, TGV wrote:
> > Thanks for the answer. 
> >
> > I had already figure out there was no c++ driver for the rfx dboard. 
> >
> > Is there any documentation we can use to develop some drivers for the RFX400
> > board in C++?
> > I was able to select the SMA connector to use and its way (RX or TX) by
> > looking in the schematic. But, for they other things like select the
> > bandwith and frequency, or simply turn on the card, I didn't find yet. I
> > assume that I could find some answer in the Python code, but it is a long
> > process. 
> > So all information will be useful. 
> >
> > Thanks again. 
>
> The relevant python code is reasonable small.
> See gr-usrp/src/db_flexrf.py
>
> Eric

I can't help but ask/beg ... if you pick up momentum and successfully 
port the RFX400 code to C++ and want to port the RFX2400 code also, I 
will send you chocolate :)

Looking at the python code, it's only converting an extra 15 lines of 
code or so over the 400 code.

- George