RE: [Ltib] MPC8313 question - again

[Tom Moulton]

If I remember correctly the SPI issue is not software, not booting Freescale
won't help.

I think GPIO 30 (or is it 31) is the SPI Select line and that was wired
wrong.

You MAY be able to do a hardware hack to get it working on a Rev A board, I
am not 100% sure.

tom

-----Original Message-----
From: address@hidden
[mailto:address@hidden On Behalf Of Mark Bishop
Sent: Tuesday, March 10, 2009 4:49 PM
To: address@hidden
Subject: [Ltib] MPC8313 question - again

I realize that this mailing list isn't a Freescale support forum, and  
I will take my issues I have with them to there 'Support Channel'.   
However, I do have a few questions that hopefully you do want to answer.

I've got a Rev A board and the two most recent RDBs cause all kinds of  
issues.  The only one I can get to work is from 2007 (2.6.20).  All I  
want is SPI enabled for this friggin board.  The 2007 RDB from  
Freescale doesn't have working SPI.

I really just want to give Freescale the boot, so I downloaded the  
most recent ltib from bitshrine and I see that it isn't one of the  
selectable platforms on the first screen.  So, here is my question: Is  
there some files from CVS that I can download to make it avail or do I  
just resign myself to trying to get actual support from Freescale?


_______________________________________________
LTIB home page: http://bitshrine.org

Ltib mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/ltib