[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Configuring the gps

From: Joseph Wagster
Subject: Re: [Paparazzi-devel] Configuring the gps
Date: Sat, 27 Aug 2011 10:19:30 -0700

We have the lea 5 h. I've been using an std I cable and the autopilot as a power regulator. I saw the battery port on the gps but I thought that was more of a backup system. I thought that we would be able to configure the gps without the battery. If the gps is unplugged it loses itsbroken config. I'll try using a battery

Thank you very much

On Aug 26, 2011 3:34 PM, "Prof. Dr.-Ing. Heinrich Warmers" <address@hidden> wrote:
> Dear Joey,
> what kind of GPS module do you use?
> Same have only ram, and when the battery is bad (discharged) they lose
> the configuration.
> In our case power on the module for a few hours charge the battery.
> Regards
> Heinrich
> Joseph Wagster schrieb:
>> Hello,
>> We somehow got the gps module to pick up satellites through u center.
>> However when we change the configuration and then go to configue
>> configue save current configuration it does not save after we cycle
>> the power. Also the tech support at u blocks told us there is an
>> acknowledge section and it does not light up has he says it would.
>> Other than the com port or the baud rate we know are right because we
>> receive the satellites, does anyone have any ideas about what we could
>> be doing wrong.
>> Thank you very much,
>> Joey
>> On Aug 24, 2011 9:50 PM, "Joseph Wagster" <address@hidden
>> <mailto:address@hidden>> wrote:
>>Paparazzi-devel mailing list

reply via email to

[Prev in Thread] Current Thread [Next in Thread]