RE: [avr-chat] how to program surface-mount micros?

[NEMEC, BENJAMIN]

Oops, I missed the tiny28 part; the only one from Atmel that's close is
the STK505 that has a 14pin ZIF.  

I don't recall ever using the parts right on the stk500, I always in
system program.  Might suggest doing development on a DIP, replacing
surface mount parts on the board after the FLASH wears out isn't much
fun.


Ben Nemec


-----Original Message-----
From: address@hidden
[mailto:address@hidden On Behalf Of
NEMEC, BENJAMIN
Sent: Wednesday, July 18, 2007 12:12 PM
To: Chris Bare; address@hidden
Subject: RE: [avr-chat] how to program surface-mount micros?

There are a family of daughter cards for the STK500 with ZIF (zero
insertion force) sockets for the non-DIP AVRs.

Go to:

http://www.atmel.com/dyn/products/tools.asp?family_id=607#808


Ben Nemec


-----Original Message-----
From: address@hidden
[mailto:address@hidden On Behalf Of
Chris Bare
Sent: Wednesday, July 18, 2007 11:53 AM
To: address@hidden
Subject: [avr-chat] how to program surface-mount micros?

I'm considering using a surface mount tiny28 in my next project to keep
overalls size down, but I've only worked with the DIP packages and am at
a
loss in how to program the surface mount ones.
I don't see any place to plug them in on the STK500, is there some kind
of
adapter? or is there a socket to adapt the suface mount chip to a DIP?

I'm pretty new to all this so please forgive what are probably obvious
questions to some.
-- 
Chris Bare
address@hidden


_______________________________________________
AVR-chat mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/avr-chat




_______________________________________________
AVR-chat mailing list
address@hidden
http://lists.nongnu.org/mailman/listinfo/avr-chat