Re: [Discuss-gnuradio] Problem with WXGUI Widgets

[Jordan Otomo]

Hi Tom,

Thanks for the help.  I've tried manually deleting all of the GNU Radio files 
in the recommended locations, reinstalling, and performing a 'sudo ldconfig', 
but the problem still persists.  You mentioned a few install directories not 
listed in the FAQ's "The problem of multiple installs" section.  Do you know if 
there are any other install files I should delete before reinstalling?  Thanks 
again!

Jordan

----- Original Message -----
From: "Tom Rondeau" <address@hidden>
To: "Jordan Otomo" <address@hidden>
Cc: address@hidden
Sent: Tuesday, October 25, 2011 12:01:30 PM
Subject: Re: [Discuss-gnuradio] Problem with WXGUI Widgets


On Tue, Oct 25, 2011 at 2:43 PM, Jordan Otomo < address@hidden > wrote: 


Hi, 

I seem to be having an issue with a few of the GRC WX GUI Widgets, namely the 
FFT Sink and Scope Sink, in the latest release (3.5.0). My flowgraphs now exit 
immediately, without error. I've constructed a simple flowgraph consisting of a 
signal source, throttle, and FFT Sink/Scope Sink to test this and it exits 
immediately after execution. The only message I receive is ">>> Done". Any help 
would be greatly appreciated. 

Thanks, 
Jordan 





It might help to remove all of the old GNU Radio installed files from your 
system (in prefix/lib/libgnuradio*, 
prefix/lib/python2.X/dist-packages/gnuradio, prefix/include/gnuradio, 
prefix/share/doc/gnuradio, prefix/share/gnuradio). 



You shouldn't have to do this, but it seems a common cause of problems when 
upgrading. 


Then reinstall and make sure to run ldconfig. 


Tom