[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

Re: [Paparazzi-devel] Blank GCS with Lisa/S

From: beryl.wicaksono
Subject: Re: [Paparazzi-devel] Blank GCS with Lisa/S
Date: Wed, 4 Mar 2015 21:01:22 -0700 (MST)

Hi Sam,

I'm sorry that my screenshot is not enough resolution. So, here I paste from
the terminal message.

[164727.824147] cdc_acm 2-2.1:1.0: ttyACM0: USB ACM device
[164740.119585] usb 2-2.1: USB disconnect, device number 16
[164766.154822] usb 2-2.1: new full-speed USB device number 17 using
[164766.433058] usb 2-2.1: New USB device found, idVendor=0484,
[164766.433063] usb 2-2.1: New USB device strings: Mfr=1, Product=2,
[164766.433065] usb 2-2.1: Product: Superbit USBRF
[164766.433066] usb 2-2.1: Manufacturer: 1 BIT SQUARED
[164766.433068] usb 2-2.1: SerialNumber: URF0089
[164766.436105] cdc_acm 2-2.1:1.0: This device cannot do calls on its own.
It is not a modem.
[164766.436121] cdc_acm 2-2.1:1.0: ttyACM0: USB ACM device

Oh I see, so to read telemetry through BMP, the superbit usbrf will not used
? I will try to debug via the BMP.
I hope that you can find the problem and the solution , so I can use the
supebit usbrf and make mys stuff fly. 

I'm looking forward for your reply. Thank you.


Beryl Wicaksono

Garrosh wrote
> Hello Beryl,
> I have looked at your screenshot, but the resolution isn't very good, so I 
> can't read the output of "$ dmesg | tail". You may copy paste it instead.
> If you want to read telemetry through the BMP, you have to use it's UART 
> capabilities, so you need to connect it to the UART of your Lisa/S. The
> BMP is 
> listed as two devices, one is for flashing (SWD) and the other is for
> telemetry 
> (UART).
> Sam
> _______________________________________________
> Paparazzi-devel mailing list

> Paparazzi-devel@


Beryl Wicaksono
Electrical Engineering
Bandung Institute of Technology
View this message in context:
Sent from the paparazzi-devel mailing list archive at

reply via email to

[Prev in Thread] Current Thread [Next in Thread]