Re: [avr-chat] Can't Install avr-gcc in FreeBSD

[龙黎]

>> Yes, I have installed the binutils to the directory /usr/local/avr

>How? With the ports collection or manually?
By manually :(

Because I have readed the section "installation" of the avr-gcc manual.
So I want to install all the avr tool-set into one directory: /usr/local/avr

That is not the proper invocation, but widely used and usually works.
But only works by accident. Make is not bound to build the targets
listed in the order listed. This is the correct way to install and
clean, the clean will not run unless install exits without error:

# make install && make clean

I am a green hand in the FreeBSD world. Thank you for the suggestions.

Finally, I have installed avr-binutils and avr-gcc. I did the following steps.
1. Delete the avr-binutils which installed by manual.
2. Refresh the ports of binutils and avr-gcc to the newest ones.
3. Install binutils and avr-gcc by ports system.

Everything is fine except the avr-libc.
I install the avr-libc before reading the suggestion of David.
He wrote:
-----------------------------------
Yes, but you also have to "make -DNOPORTDOCS install"

The BROKEN line stops the build immediately. Remove BROKEN and it will
try. -DNOPORTDOCS is required to keep the build out of the problem
support utilities where the breakage occurs.
-----------------------------------
Now, the port system is fetching the big file "tetex", OK, I don't want to stop it :)

If it fail, I'll try your new methods.

FreeBSD is a great system, thanks for the avr tools and the people who created them.

Atommann from China