Re: Macro for(UP_and_DOWN) and 3 similar. (issue 2491) (issue 6109046)

[Łukasz Czerwiński]

Could you please change the mails' subject? :) I've started a thread:

Lilypond patchy and other Lilypond problems

 for this discussion. Could you move there?

Łukasz

On 27 April 2012 19:43, Phil Holmes <address@hidden> wrote:

----- Original Message ----- From: "James" <address@hidden>
To: "Phil Holmes" <address@hidden>
Cc: <address@hidden>; <address@hidden>; <address@hidden>; <address@hidden>
Sent: Friday, April 27, 2012 5:58 PM

Subject: Re: Macro for(UP_and_DOWN) and 3 similar. (issue 2491) (issue 6109046)

You then need to tick a box more or two to enable that stuff in VBox
or KVM. Remember though that LilyDev is 32bit so if you use KVM you
must not go over 4096 for your RAM (even if you have more) else, I
found, it will just default to 128mb! Vbox is a bit more smart, but
you still cannot address more than 4GB of RAM in a 64bit VBox install
using LilyDev.

That said, I've never seen Lily builds take much RAM, so 4 GByte is normally plenty.

--
Phil Holmes

_______________________________________________
lilypond-devel mailing list
address@hidden
https://lists.gnu.org/mailman/listinfo/lilypond-devel