[Top][All Lists]

[Date Prev][Date Next][Thread Prev][Thread Next][Date Index][Thread Index]

[Paparazzi-devel] Electrical connections in the airborne equipment.

From: Helge Walle
Subject: [Paparazzi-devel] Electrical connections in the airborne equipment.
Date: Wed, 14 Jul 2010 14:17:35 +0200

Here is a simple sketch showing how I would like to power the onboard electronics in a TWOG setup.
The plan is to use these connections for my next plane. On my current TwinstarII I use +5V from the TWOG to power the servos. Compared to the sketch the difference is that +5V is now taken from the BEC.
There is a jumper on the PPM board for separating the +5V connection, but I kept it in place and just left out the +5V lead between the PPM board and TWOG.
I use 6-7cm long servo cables between the R/C receiver and PPM board. Do you think that the +5V and Gnd in parallell in each servo cable represents a problem?
Any comments would be welcome.
Circuit diagram
Best regards,

reply via email to

[Prev in Thread] Current Thread [Next in Thread]